Look up Error Messages

Look at the output from running the in.dhcpd command in debug mode and use the error message or condition you see to find a solution from the information below.

Problem

You see one of the following error messages:

Datagram received on network device: le0

ICMP ECHO reply to OFFER candidate: ip_address disabling

Verification: Before the DHCP server offers an IP address to a client, it verifies that the IP address is not in use by pinging the IP address. If a client replies, the IP address is in use.

Solution: Make sure the IP addresses you configured are not already in use.

Problem

You see the following error message:

No more IP addresses for network_address network

Verification: There are no available IP addresses in the client's dhcp_network table.

Solution: Use the dhcpconfig command to allocate more IP addresses. If the DHCP daemon is monitoring multiple subnets, be sure the additional IP addresses are for the subnet where the client is located.

Problem

There is a bad client id: id_name in the dhcp_network database.

Verification: The client ID (MAC address) in the dhcp_network table is incorrect.

Solution: If you are using Ethernet, the client ID is 01 followed by the Ethernet address. Make sure that all letters in this address are capitalized. A 00 means the address has not been assigned.

Problem

You see the following error message:

Request to access nonexistent dhcp_network database: database_name in datastore: nisplus_datastore.

Verification: The dhcpconfig script did not create a dhcp_network table for a subnet during the configuration of the DHCP server. This can happen if you set up an isolated LAN, such as a server and two clients, as a test network.

Solution: Use the dhcpconfig command to initialize the dhcp_network table and new IP addresses.

Problem

You receive the error message:

Client client_id is trying to verify unrecorded address ip_address, ignored.

Verification: There are two possible reasons for getting this message:

1. You can receive this message if your dhcp_network tables have been deleted. If you are using only the Solaris 2 DHCP server, then this is typically the reason.

2. You can receive it if you are not using NIS+ for datastore, so information is not shared. Make sure that the server is sharing data.

If you have a group of heterogenous servers, then ignore this message.

Solution: Remove old cache files on the client by typing:

ifconfig interface_name dhcp release

Problem

DHCP is started, but some required network services will not start.

Verification: The DHCP server is not supplying the configurations required.

Solution: Find out why the server does not send the parameters that are required. Configure the server to do so.

Problem

DHCP is started, but certain network services, such as NIS and NIS+, report errors or hang. The host cannot communicate with other hosts on the network.

Verification: The dhcpagent command was unable to communicate with DHCP (presumably because DHCP was unavailable) and has used cached data.

Solution: Remove the cache. Type:

ifconfig interface_name dhcp release

Since removing the cache does not solve the problem of getting the proper configuration, the host may have to be configured by hand. At boot time, DHCP should be disabled by removing the trigger file by typing:

rm /etc/dhcp.interface_name

Problem

The client boots and works correctly, but the following message appears:

DHCP renewal on interface_name failed

Verification: DHCP is working, but dhcpagent cannot contact the server to extend the lease.

Solution: Find out why the server is not responding now. This could be because the router value configured in the dhcptab is incorrect or out of date for the client network.

Problem

Messages about failed DHCP renewals are received. Then the following message appears on the console:

DHCP lease expired on interface_name: interface is now down

Network services may hang at this point.

Verification: The lease has expired. The client has not been able to extend the lease after several attempts.

Solution: Find out why the server is not responding. Reboot the client.