Performance Tuning Guide > Tuning UNIX Operating Systems for Performance > Tuning Siebel eBusiness Applications for AIX >

Tuning the IBM HTTP Server for AIX

This section describes recommended values for environment variables that are optimized for scalability and performance on IBM HTTP Server (IHS) Web server. You can further adjust these settings at your discretion to optimize the performance of your Web server.

The following environment variables are set in Webserver_Root/bin/startapa, where Webserver_Root is the root directory in which your Web server is installed:

export AIXTHREAD_SCOPE=S
export AIXTHREAD_MNRATIO=1:1
export AIXTHREAD_MUTEX_DEBUG=OFF
export AIXTHREAD_RWLOCK_DEBUG=OFF
export AIXTHREAD_COND_DEBUG=OFF
export CORE_NAMING=Siebel
export YIELDLOOPTIME=number_of_CPUs_on_Web_server_machine
export SPINLOOPTIME=1000
export MALLOCMULTIHEAP=heaps:number_of_CPUs_on_Web_server_machine,considersize
export MALLOCTYPE=buckets
export LDR_CNTRL=IGNOREUNLOAD@LOADPUBLIC@PREREAD_SHLIB@MAXDATA=0x60000000

For the MALLOCMULTIHEAP and YIELDLOOPTIME parameters, the values should include the number of CPUs on the Web server machine. For example, if there are two CPUs, these parameters should be defined as follows:

export MALLOCMULTIHEAP=heaps:2,considersize
export YIELDLOOPTIME=2

To set the number of threads for IBM HTTP Server

1. Using a text editor, set values for parameters in the workers.c section of the file Web_server_install/conf/httpd.conf, where Web_server_install is the root directory in which your Web server is installed. Set the parameter values as follows:

   ThreadLimit	N
   StartServers	1
   ServerLimit	1
   MaxClients	N
   MinSpareThreads	1
   MaxSpareThreads	N
   ThreadsPerChild	N
   MaxRequestsPerChild	0

   where:

   N = a value similar to 1.2 or 1.5 * maximum number of concurrent users (threads). The value for the applicable parameters must be greater than the number of concurrent users the Web server must support. However, setting parameter values higher than what is described here will consume additional memory unnecessarily.

2. In the file httpd.conf, also set the following values:
   • The value for ServerName must match the Primary Internet Address you used in installing SWSE.
   • Change the values for User and Group to a valid machine user and group:
     • Ideally, the user ID should have no privileges that allow access to files other than those used by the Siebel application. This user should, however, have full access rights (read, write, execute) to the SWSE installation directory and its subdirectories.
     • It is recommended that the group should be created specifically for running this server.

       CAUTION:  For security reasons, it is recommended that you do not use root for User or Group.

   • The value for UseCanonicalName is recommended to be set to Off. It must be set to Off if you are load-balancing your Web servers.
   • If you are not using the CGI functionality of IHS, you may want to comment out the line that loads the CGI module. Doing so will make tracking IHS processes simpler, because there will be always one child process. The line is as follows:

   LoadModule cgid_module modules/mod_cgid.so