Siebel Server Administration Guide > Siebel Enterprise Server Architecture >

Siebel Enterprise Server

The Siebel Enterprise Server is a logical grouping of Siebel Servers that support the same group of users accessing a common Siebel Database Server. The Siebel Enterprise Server can be configured, managed, and monitored as a single logical group, allowing the Siebel administrator to start, stop, monitor, or set parameters for Siebel Servers within a Siebel Enterprise Server.

You can set some Siebel Server parameters at the Siebel Enterprise Server level, and these parameters will apply to every Siebel Server and component operating within that Siebel Enterprise Server; other parameters can be adjusted at the Siebel Server or component level to support fine-tuning.If a parameter is set at the server level, this value will be used instead of the setting for the same parameter at the Siebel Enterprise Server level.

Each Siebel Server that connects to a common database schema must be installed within the same Siebel Enterprise Server.

The Siebel Enterprise Server itself has no processes and, therefore, cannot have a state. However, you can start and shut down operations at the Siebel Enterprise Server level, and these actions will apply to every Siebel Server within that Siebel Enterprise Server.

For information on administering the Siebel Enterprise Server, see Siebel Enterprise Server Administration.

NOTE:  Make sure server hardware and software requirements meet your Siebel application's minimum standards. For more information, see the system requirements and supported platforms document for your Siebel application. (Release notes and the system requirements and supported platforms document for Siebel applications can be found on Siebel SupportWeb at http://ebusiness.siebel.com/supportweb/.)


 Siebel Server Administration Guide, Version 7.5, Rev. C 
 Published: 18 April 2003