---

3. TMADMIN Messages 400-499

---

473	ERROR: Error reading file filename
	Description	An attempt to read a saved Bulletin Board failed.
	Action	The BB may be the wrong size or corrupted, or the specified file may not be a saved BB.
	See Also	tmadmin(1)
474	ERROR: Error setting auth type to CLIENT
	Description	An attempt to open a saved Bulletin Board file failed.
	Action	Check to see that the specified file exists and that you have read permission.
	See Also	tmadmin(1)
475	ERROR: Error setting bb type to PRIVATE
	Description	An attempt to attach to a saved bulletin board failed.
	Action	Contact your BEA TUXEDO system Technical Support.
	See Also	tmadmin(1)
476	ERROR: Error attaching to private bulletin board
	Description	An attempt to attach to a saved bulletin board failed.
	Action	Contact your BEA TUXEDO system Technical Support.
	See Also	tmadmin(1)
477	ERROR: Error opening file filename
	Description	An attempt to open a saved bulletin board failed.
	Action	Contact your BEA TUXEDO system Technical Support.
	See Also	tmadmin(1)
494	ERROR: Cannot stop processes from non-master node
	Description	The shutdown command invokes tmshutdown(1) to shut down processes. Because tmshutdown(1) needs access to the DBBL for successful processing, it must run on the master node (that is, where the DBBL resides).
	Action	Consult the MASTER keyword of the RESOURCES section of the ubbconfig(5) file to determine your application's master node. This is the node on which tmadmin(1)'s shutdown command must be executed. Note that if the master command was previously executed, the DBBL may be running on the backup node instead. In this case, the shutdown command must be executed from tmadmin(1) running on the backup node.
	See Also	tmadmin(1), tmshutdown(1), ubbconfig(5)
498	ERROR: The new value is not within the range of min-max
	Description	This message is printed when an illegal value has been given to one of the changeload, changepriority, or changetrantime commands of tmadmin(1). Service loads must be between 1 and 32767, inclusive; service priorities must be between 1 and 100, inclusive; and transaction times must be between 0 and 2,147,483,647, inclusive.
	Action	Re-enter the command using a value within the appropriate range. The SERVICES section of the ubbconfig(5) manual page describes the correct ranges and defaults for these service attributes.
	See Also	ubbconfig(5)
499	ERROR: Error changing value
	Description	An error was encountered trying to update a service's priority with the changepriority command, or its transaction timeout value with the changetrantime command. This error may have occurred because of a communication failure between tmadmin(1) and the DBBL or one of the BBLs.
	Action	Check the userlog(3c) file to see if a communication error occurred that caused the requested command to fail.

---

---