TMADMIN Messages 400-499
|
|
|
473
ERROR: Error reading file filename
Description
An attempt to read a saved Bulletin Board failed.
Action
The BB may be the wrong size or corrupted, or the specified file may not be a saved BB.
See Also
tmadmin(1)
474
ERROR: Error setting auth type to CLIENT
Description
An attempt to open a saved Bulletin Board file failed.
Action
Check to see that the specified file exists and that you have read permission.
See Also
tmadmin(1)
475
ERROR: Error setting bb type to PRIVATE
Description
An attempt to attach to a saved bulletin board failed.
Action
Contact your BEA TUXEDO system Technical Support.
See Also
tmadmin(1)
476
ERROR: Error attaching to private bulletin board
Description
An attempt to attach to a saved bulletin board failed.
Action
Contact your BEA TUXEDO system Technical Support.
See Also
tmadmin(1)
477
ERROR: Error opening file filename
Description
An attempt to open a saved bulletin board failed.
Action
Contact your BEA TUXEDO system Technical Support.
See Also
tmadmin(1)
494
ERROR: Cannot stop processes from non-master node
Description
The shutdown command invokes tmshutdown(1) to shut down processes. Because tmshutdown(1) needs access to the DBBL for successful processing, it must run on the master node (that is, where the DBBL resides).
Action
Consult the MASTER keyword of the RESOURCES section of the ubbconfig(5) file to determine your application's master node. This is the node on which tmadmin(1)'s shutdown command must be executed. Note that if the master command was previously executed, the DBBL may be running on the backup node instead. In this case, the shutdown command must be executed from tmadmin(1) running on the backup node.
See Also
tmadmin(1), tmshutdown(1), ubbconfig(5)
498
ERROR: The new value is not within the range of min-max
Description
This message is printed when an illegal value has been given to one of the changeload, changepriority, or changetrantime commands of tmadmin(1). Service loads must be between 1 and 32767, inclusive; service priorities must be between 1 and 100, inclusive; and transaction times must be between 0 and 2,147,483,647, inclusive.
Action
Re-enter the command using a value within the appropriate range. The SERVICES section of the ubbconfig(5) manual page describes the correct ranges and defaults for these service attributes.
See Also
ubbconfig(5)
499
ERROR: Error changing value
Description
An error was encountered trying to update a service's priority with the changepriority command, or its transaction timeout value with the changetrantime command. This error may have occurred because of a communication failure between tmadmin(1) and the DBBL or one of the BBLs.
Action
Check the userlog(3c) file to see if a communication error occurred that caused the requested command to fail.
 |
 |
 |