2.11 FS-10500 to FS-10549

FS-10500 %s : Starting verification of cluster %s

Cause: Starting to verify the cluster.

Action: This is an informational message. No action is needed.

FS-10501 %s : Verifying the Oracle Services for MSCS installation

Cause: Starting to verify the Oracle Services for MSCS installation on all cluster nodes.

Action: This is an informational message. No action is needed.

FS-10502 %s : Verifying the Oracle homes

Cause: Starting to verify the Oracle homes on the cluster.

Action: This is an informational message. No action is needed.

FS-10503 %s : Verifying the network configuration

Cause: Starting to verify the cluster network and node name mappings.

Action: This is an informational message. No action is needed.

FS-10504 %s : Verification of the cluster completed

Cause: Completed the verification of the cluster.

Action: This is an informational message. No action is needed.

FS-10505 The Oracle Net configuration on %s is not configured for IP address %s in home %s. Add address to listener %s?

Cause: The specified node maps to multiple IP addresses. Because the Oracle Net listener is not configured to fully listen on all specified IP addresses, clients may not be able to connect to databases on the specified node.

Action: Click Yes in the error message window if you want Oracle Services for MSCS to add the IP addresses to the Oracle Net listeners. Click No if you want to try to fix the problem yourself.

FS-10506 Starting to add IP address %s to listeners in Oracle home %s on node %s

Cause: Starting to add the specified IP address to the Oracle Net listener or listeners in the specified home on the specified node.

Action: This is an informational message. No action is needed.

FS-10507 ** ERROR: Failed to start listener %s after adding IP address. Beginning rollback

Cause: After Oracle Services for MSCS added an IP address to the specified listener, the listener was unable to start.

Action: This is an informational message. See warning messages of the operation.

FS-10508 ** ERROR: Failed to stop listener %s. Beginning rollback

Cause: The operation failed to stop the specified listener before starting the listener again with a new IP address included.

Action: This is an informational message. See warning messages of the operation.

FS-10509 Rolling back changes to listener %s

Cause: Changes to the specified listener are being rolled back.

Action: This is an informational message. No action is needed.

FS-10510 %s network on the cluster uses subnet %s

Cause: Obtained cluster network information from Microsoft Cluster Services.

Action: This is an informational message. No action is needed.

FS-10511 Clusterwide validation of the %s : %s

Cause: Comparing the host name information among all nodes.

Action: This is an informational message. No action is needed.

FS-10512 %s maps to %s on %s

Cause: This is the mapping of a host name to an IP address as seen on a host.

Action: This is an informational message. No action is needed.

FS-10513 %s maps to %s on %s

Cause: This is the mapping of a host name to an IP address or IP addresses configured on a host.

Action: This is an informational message. No action is needed.

FS-10514 ** WARNING: The IP mappings may cause problems. See warning message that follows

Cause: There are incorrect IP mappings.

Action: See the warning message.

FS-10515 %s host IP translation is inconsistent. The order of network adapters may be wrong. See the documentation

Cause: The translation of the host name to an IP address is not consistent for all client and cluster nodes. Either the host name is not registered correctly, or the order of the network adapters is incorrect. On a system with multiple network adapters, problems can arise with products relying on the network (such as Oracle Intelligent Agent or Oracle Net Listener) if the first network adapter seen by Windows is not configured to use the IP address known by the rest of the system.

Action: See the Oracle Fail Safe Concepts and Administration Guide for detailed information on this problem and suggested workarounds.

FS-10516 %s host IP translation is inconsistent and Oracle Services for MSCS cannot work. Check name service or host file

Cause: The nodes in the cluster have an incorrect IP address configuration. During an Oracle Services for MSCS operation, Oracle Database and Oracle Services for MSCS components communicate with each other using the TCP/IP network transport. It is essential that each host name used is mapped to the correct IP address on all systems involved. Oracle Services for MSCS has compared the IP address mapping of the specified host on all nodes of the cluster and on the node where the manager is running. It found that not all nodes return the same IP address for this host name. This problem is usually caused by inconsistent mapping between the host name and the IP address mapping being registered among these nodes.

Action: Fix the name service (DNS, WINS) or HOSTS file to map the host to the same IP address among all involved nodes (the cluster nodes and the node on which the manager runs).

FS-10517 Cannot load network information on node %s

Cause: Unable to load network information on the node. On the system where you run the manager, this host name may be mapped to an incorrect IP address.

Action: Check that the host name to IP address mapping is correct on the system where you run the manager.

FS-10518 The Oracle Net configuration for node %s is not configured for IP address %s. Add address to listener?

Cause: The specified node maps to multiple IP addresses. Because the Oracle Net listener for this node is not configured to listen on the specified IP address, clients may not be able to connect to databases.

Action: It is highly recommended that you fix this problem. To fix the problem, rerun the Verify Cluster command.

FS-10519 The Oracle Net configuration for node %s has no listener. Create a listener for the IP address %s

Cause: The specified node maps to multiple IP addresses. Because the Oracle Net configuration has no listener, clients may not be able to connect to databases.

Action: It is highly recommended that you fix this problem. To fix the problem, create a listener and then rerun the Verify Cluster command.

FS-10520 %s has Oracle in %s

Cause: Querying the information from the specified host.

Action: This is an informational message. No action is needed.

FS-10521 Oracle home %s version %s exists on nodes : %s

Cause: This message lists the nodes on which the specified home exists.

Action: This is an informational message. No action is needed.

FS-10522 ** WARNING: Oracle home %s version %s exists on nodes : %s and not on nodes : %s

Cause: The Oracle homes are not the same on all nodes of the cluster.

Action: Reinstall Oracle so that the Oracle homes are the same on all nodes of the cluster.

FS-10524 Oracle homes are not the same on all nodes of the cluster. Oracle Services for MSCS may fail on certain operations

Cause: The Oracle homes are not the same on all nodes of the cluster. Most clusterwide operations are applied to the same Oracle home on all cluster nodes. Therefore, these operations will work only if the same Oracle home exists on each node of the cluster. See the Oracle Fail Safe Concepts and Administration Guide for more information on the interaction between Oracle homes and Oracle Services for MSCS.

Action: Reinstall Oracle so that the Oracle homes are the same on all nodes of the cluster.

FS-10525 Cannot load Oracle installation information on node %s

Cause: The attempt to load Oracle installation information on the node has failed. On the system where you run the manager, this host name may be mapped to an incorrect IP address.

Action: Check that the host name to IP address mapping is correct on the system where you run the manager.

FS-10526 Unable to report the state of the clusterwide operation - access was denied

Cause: A cluster node was unable to display a message or error to the Oracle Fail Safe console because it does not have the correct privileges.

Action: Run the Oracle Services for MSCS Security Setup on all nodes of the cluster. To run the setup program, click Start, then Programs, then Oracle - Oracle_Home, then Oracle Services for MSCS Security Setup. Make sure the same user account information is specified on each node of the cluster.

FS-10530 %s has Oracle Services for MSCS version %s

Cause: The specified version of Oracle Services for MSCS is installed on the specified node.

Action: This is an informational message. No action is needed.

FS-10532 The Oracle Services for MSCS version is not the same on all cluster nodes. Oracle Services for MSCS may not work

Cause: The Oracle Services for MSCS software is incorrectly installed. The same version of Oracle Services for MSCS must be installed on each cluster node.

Action: Reinstall the Oracle Services for MSCS software correctly on all cluster nodes.

FS-10533 Cannot load Oracle Services for MSCS information on node %s

Cause: The attempt to load Oracle Services for MSCS information on the node has failed. On the system where you run the manager, the host name may be mapped to an incorrect IP address.

Action: Check that the host name to IP address mapping is correct on the system where you run the manager.

FS-10534 %s has %s

Cause: The specified resource DLL is on the specified cluster node.

Action: Check that this is the expected result, based on the installation of Oracle Services for MSCS.

FS-10535 Oracle Services for MSCS has modified properties of the resource type %s

Cause: Oracle Services for MSCS was unable to read properties of the specified resource type, so it modified the resource type DLL to point to the correct resource DLL. The resource DLL is named FsResOdbs.dll.

Action: Make sure that the Oracle resource type DLL (FsResOdbs.dll) exists in the directory where Oracle Services for MSCS is installed, and that the directory is in the system and user paths. Restart all cluster nodes.

FS-10536 Unable to locate the Oracle database resource DLL on node %s

Cause: Unable to find the Oracle database resource DLL.

Action: Make sure that Oracle database resource DLL, FsResOdbs.dll, exists in the directory where Oracle Services for MSCS is installed. If not, reinstall Oracle Services for MSCS.

FS-10537 Oracle Services for MSCS is unable to register the Oracle database resource DLL with the cluster

Cause: Unable to register the Oracle database resource DLL with the cluster.

Action: Make sure that the Oracle database resource DLL, FsResOdbs.dll, exists in the directory where Oracle Services for MSCS is installed, and that the directory is in the system and user paths.

FS-10538 You must restart all cluster nodes for the change(s) to take effect

Cause: Oracle Services for MSCS is unable to read the property of the resource type, so it modified the resource type DLL to point to the correct resource DLL (FsResOdbs.dll for the Oracle database resource).

Action: Make sure that the Oracle resource DLL, FsResOdbs.dll, exists in the directory where Oracle Services for MSCS is installed and that the directory is in the system and user paths, then restart all cluster nodes.

FS-10539 It is recommended that the Verify Group operation be run against group %s

Cause: A new installation of Oracle Fail Safe has been performed and there are existing Fail Safe groups in the cluster.

Action: Run the Verify Group operation against the specified groups.

FS-10540 Failed to verify the cluster

Cause: Unable to verify the cluster.

Action: Check the secondary error.

FS-10541 ** WARNING: Cannot load information on node %s

Cause: The attempt to load information on the specified node has failed. On the system where you run the manager, the host name may be mapped to an incorrect IP address.

Action: Check that the mapping between the host name and IP address is correct on the system where you run the manager.

FS-10542 Cannot load information from all nodes to perform a complete verify cluster operation

Cause: The attempt to load information on a certain node has failed. On the system where you run the manager, the host name may be mapped to an incorrect IP address.

Action: Check that the mapping between the host name and IP address is correct on the system where you run the manager.

FS-10543 A multinode cluster cannot have a quorum resource of type Local Quorum

Cause: The cluster quorum resource must reside on a cluster disk when there are two or more nodes in the cluster. The cluster quorum resource is using a resource type of Local Quorum.

Action: Use MSCS Cluster Administrator to change the cluster quorum resource.

FS-10544 %s : Verifying the cluster quorum resource

Cause: Starting to verify the cluster quorum resource.

Action: This is an informational message. No action is needed.

FS-10545 Cluster quorum resource %s is located at %s

Cause: During the Verify Cluster operation, the quorum resource is displayed along with its location.

Action: This is an informational message. No action is needed.

FS-10546 Resource %s with a resource type of Local Quorum was detected in the cluster

Cause: The Verify Cluster operation found a resource type of Local Quorum.

Action: If the Local Quorum resource is not needed, use the MSCS Cluster Administrator to delete the resource.

FS-10547 The Oracle home bin directory %s is not in the PATH environment variable

Cause: The PATH environment variable is inconsistent with the Oracle installation.

Action: Fix the PATH environment variable and restart the system.

FS-10548 The PATH environment variable is missing an Oracle Services for MSCS bin directory %s

Cause: You must restart the cluster nodes after installing Oracle Services for MSCS. It is likely that the nodes have not been restarted.

Action: Restart the cluster nodes.

FS-10549 Unable to load Oracle Services for MSCS resource DLL %s for resource type %s

Cause: Unable to load the named resource DLL.

Action: Check the Oracle Services for MSCS installation to make sure that the corresponding Oracle Services for MSCS component is installed.