MySQL 5.6 Reference Manual Including MySQL NDB Cluster 7.3-7.4 Reference Guide
You can change the default installation path, the data path, or both when you install MySQL server. After you have installed the server, the paths cannot be altered without removing and reinstalling the server instance.
To change paths for MySQL server
Identify the MySQL server to change and enable the Advanced Options link.
Navigate to the Select Products page by doing one of the following:
If this is an
initial
setup of MySQL Installer, select the
Custom
setup type and click
.
If MySQL Installer is installed already, launch it from the Start menu and then click
from the dashboard.Click Available Products (see Locating Products to Install.
to apply a filter on the product list shown inWith the server instance selected, use the arrow to move the selected server to the Products To Be Installed list.
Click the server to select it. When you select the server, the Advanced Options link is enabled below the list of products to be installed (see the following figure).
Click Advanced Options to open a dialog box where you can enter alternative path names. After the path names are validated, click to continue with the configuration steps.