MySQL 5.6 Reference Manual Including MySQL NDB Cluster 7.3-7.4 Reference Guide
There are some errors that apply only to subqueries. This section describes them.
Unsupported subquery syntax:
ERROR 1235 (ER_NOT_SUPPORTED_YET) SQLSTATE = 42000 Message = "This version of MySQL doesn't yet support 'LIMIT & IN/ALL/ANY/SOME subquery'"
This means that MySQL does not support statements of the following form:
SELECT * FROM t1 WHERE s1 IN (SELECT s2 FROM t2 ORDER BY s1 LIMIT 1)
Incorrect number of columns from subquery:
ERROR 1241 (ER_OPERAND_COL) SQLSTATE = 21000 Message = "Operand should contain 1 column(s)"
This error occurs in cases like this:
SELECT (SELECT column1, column2 FROM t2) FROM t1;
You may use a subquery that returns multiple columns, if the purpose is row comparison. In other contexts, the subquery must be a scalar operand. See Section 13.2.10.5, “Row Subqueries”.
Incorrect number of rows from subquery:
ERROR 1242 (ER_SUBSELECT_NO_1_ROW) SQLSTATE = 21000 Message = "Subquery returns more than 1 row"
This error occurs for statements where the subquery must return at most one row but returns multiple rows. Consider the following example:
SELECT * FROM t1 WHERE column1 = (SELECT column1 FROM t2);
If SELECT column1 FROM t2
returns just
one row, the previous query works. If the subquery returns
more than one row, error 1242 occurs. In that case, the
query should be rewritten as:
SELECT * FROM t1 WHERE column1 = ANY (SELECT column1 FROM t2);
Incorrectly used table in subquery:
Error 1093 (ER_UPDATE_TABLE_USED) SQLSTATE = HY000 Message = "You can't specify target table 'x' for update in FROM clause"
This error occurs in cases such as the following, which attempts to modify a table and select from the same table in the subquery:
UPDATE t1 SET column2 = (SELECT MAX(column1) FROM t1);
You can use a subquery for assignment within an
UPDATE
statement because
subqueries are legal in
UPDATE
and
DELETE
statements as well as
in SELECT
statements.
However, you cannot use the same table (in this case, table
t1
) for both the subquery
FROM
clause and the update target.
For transactional storage engines, the failure of a subquery causes the entire statement to fail. For nontransactional storage engines, data modifications made before the error was encountered are preserved.