Gathering Data From the Screen

You can use several commands to gather system information from the Screen. This information may be requested by Sun Service, should you encounter problems with your Screen.

These commands should only be used for debugging in conjunction with a support call.

To use the ssadm lib/statetables Command

To see internal statetable information, type:

# ssadm lib/statetables

To Use the ssadm lib/screeninfo Command

This command gathers a complete set of data for your Sun Service representative, including:

• State tables

• ARP table information

• Disk usage

• Streams information

• SunScreen configuration information and files

• Uptime

• SKIP information

At the command line prompt, type:

# ssadm lib/screeninfo > output_filename

To Use the ssadm lib/nattables Command

1. To list the contents of the internal NAT tables, type:

   # ssadm lib/nattables

To Use the ssadm lib/support Command

This command gives you access to the commands in the support directory, all of which are invoked by the screeninfo command. However, if you are seeking limited data, you may want to run this command alone.

At the command line prompt, type:

# ssadm lib/support subcommand [parameters...]

See the following procedure for information on the subcommands or parameters used with this CLI.

To Use the ssadm lib/support help Option

At the command line prompt, type:

# ssadm lib/support help

A list of the subcommnads is displayed.