To configure the remote IPC over Ethernet feature, set the IPC_REMOTE
feature to true and the IPC_REMOTE_COMM
feature to EXT (mentioned
in "IPC Feature Configuration"). In addition, switch on the IOM_IPC
feature:
% configurator -set IOM_IPC=true |
This adds the Ethernet-specific module into the IOM component which acts as the IPC Ethernet data-link driver.
Once you have built and booted the ChorusOS system image on the target
board tgtbd1
, the IPC Ethernet
data-link can be dynamically started. Use the built-in ethIpcStackAttach command of C_INIT
(running on the target
board tgtbd1
) :
% rsh tgtbd1 ethIpcStackAttach ethernet-device-name |
The ethernet-device-name argument is the
name of your Ethernet device with which your remote IPC
stack will communicate. This name is the full pathname of the Ethernet device
in the target device tree, displayed on the target system console by the system
at boot time. For example, a genesis2
board with
a dec21140
Ethernet controller connected through
a raven
PCI bridge, has the pathname /raven/pci1011,9@e,0. This argument is only needed when the target
board has more than one Ethernet controller.
See the ethIpcStackAttach(1M) man page for more details.
The following example describes how to build a ChorusOS system image
for two similar PowerPC-based target boards, tgtbd1
and tgtbd2
, each with an Ethernet controller. Site
numbers must be unique and statically configured in each ChorusOS system
image.
Configure Remote IPC over Ethernet, if not already configured:
% configurator -set IPC=true % configurator -set IPC_REMOTE=true % configurator -set IPC_REMOTE_COMM=EXT % configurator -set IOM_IPC=true |
Assign a site number to tgtbd1
,
then build and uniquely identify the ChorusOS system image:
% configurator -set chorusSiteId=1 % make chorus % mv chorus.RAM chorus.RAM.tgtbd1 |
Assign a site number to tgtbd2
, then build
and uniquely identify the ChorusOS system image:
% configurator -set chorusSiteId=2 % make chorus % mv chorus.RAM chorus.RAM.tgtbd2 |
Once you have booted the chorus.RAM.tgtbd1 system image on tgtbd1
and the chorus.RAM.tgtbd2 system image on tgtbd2
,
run the ethIpcStackAttach command:
% rsh tgtbd1 ethIpcStackAttach % rsh tgtbd2 ethIpcStackAttach |
Applications which need to communicate through remote IPC
can now be launched on the tgtbd1
and tgtbd2
targets.