Initialization Examples

These are typical commands of the sysadm.ini file.

• Associate ifnet interface 0 to a specific Ethernet driver:

  % mkdev ifeth 0 /pci/epic/epic100

  The pathname is optional. For more information, refer to mkdev(1M).

  ---

  Note -

  In the ChorusOS operating system, hardware devices are identified by a path in a device tree; the mkdev command connects to the driver instance servicing the indicated hardware device.

  ---

• Associate ifnet interface 0 to the first Ethernet driver found:

  % mkdev ifeth 0

• Define the IP address of ifnet interface 0:

  % ifconfig ifeth 0 ip-address netmask ip-mask broadcast broadcast-addr

• Define the IP address using the rarp protocol on ifnet interface 0:

  % rarp ifeth 0

• Associate a special device to a serial line driver:

  % mknod /dev/tty01 c 0 0 % mkdev tty 0 /pci/pci-isa/ns16550-2

  The third argument to mknod, 0, is the major device number identifying the serial line driver. The fourth argument to mknod, 0, is the minor device number identifying the hardware device at the POSIX level.

• Mount a local file system by defining required devices, then mount the disk:

  % mknod /dev/sd0a b 10 0 % mknod /dev/rsd0a c 9 0 % mount /dev/sd0a /

• Mount a remote file system:

  % mount host-ip-addr:host-path /