SPARC: Sun StorEdge D1000 Cabling Diagrams

SPARC: Installing a Sun StorEdge D1000 Storage Array

Connect the cables to the storage arrays, as shown in Figure 3–6.

Ensure that the entire bus length that is connected to each storage array is less than 25 m. This measurement includes the cables to both nodes, as well as the bus length that is internal to each storage array, node, and the host adapter.

Figure 3–6 SPARC: Installing a Sun StorEdge D1000 Mirrored-Pair Configuration: An Example

SPARC: Adding a Sun StorEdge D1000 Storage Array

Ensure that the entire SCSI bus length to each enclosure is less than 25 m. This measurement includes the cables to both nodes, as well as the bus length that is internal to each enclosure, node, and host adapter. Refer to the documentation that shipped with the enclosure for other restrictions about SCSI operation.

Figure 3–7 SPARC: Adding a Sun StorEdge D1000 Mirrored-Pair Configuration: Part 1

Connect the storage array to the host adapters by using differential SCSI cables as shown in see Figure 3–8.

Figure 3–8 SPARC: Adding a Sun StorEdge D1000 Mirrored-Pair Configuration: Part 2

SPARC: Replacing a Sun StorEdge D1000 Storage Array

Disconnect the SCSI cables from the storage array. Remove the SCSI cables in the order that is shown in Figure 3–9.

Figure 3–9 SPARC: Disconnecting the SCSI Cables From a Sun StorEdge D1000 Storage Array

SPARC: Removing a Sun StorEdge D1000 Storage Array

Disconnect the SCSI cables from the storage array. Remove the SCSI cables in the order that is shown in Figure 3–10.

Figure 3–10 SPARC: Disconnecting the SCSI Cables From a Sun StorEdge D1000 Storage Array