How to Verify the Installation and Configuration of the Domain Administration Server (DAS)

In this procedure, a two-node cluster is used, where the nodes are identified as Node1 and Node2. The following actions were performed in How to Configure and Activate Network Resources.

• The failover DAS resource group DAS-resource-group was created.

• The failover IP address IP-address was added as a network resource to the resource group.

• The resource group was brought online, and the resources were enabled.

Steps

1. On Node1, start DAS manually, using the asadmin command.

   ---

   Note –

   The Domain Administration Server must have been configured to listen on the failover IP address IP-address.

   ---

2. Connect to the administrative console from a browser.

   https://IP-address:port

3. Verify that you are connected to the administrative console.

4. On Node1, stop DAS manually, using the asadmin command.

5. Switch the DAS resource group from Node1 to Node2.

   # scswitch -z -g DAS-resource-group -h Node2

   This step takes the resource group offline from Node1 and brings the same resource group online on Node2. The resource group includes the logical IP address IP-address.

6. On Node2, start DAS manually, using the asadmin command.

7. Connect to the administrative console from a browser.

   https://IP-address:port

   If you are not able to connect to the administrative console from the browser, perform the following actions.

   • Ensure that your installation satisfies the restrictions and requirements in Configuration Restrictions and Requirements.

   • Ensure that you correctly followed the instructions in How to Install and Configure the Sun Java System Application Server.

8. On Node2, stop DAS manually, using the asadmin command.