Run sciconf
Run the command sciconf as root on the node that contains the new SCI adapter card. This will initialize the card so it can be used by the local SCI driver software. In the following example, sciconf is run on a node that has been added to an existing network. This node contains a single SCI adapter whose serial number is 6269. The sciconf output indicates the network ID and SBus slot of this SCI adapter.
# /opt/SUNWsci/bin/sciconf Dolphin SCI SBus2b card configuration script == Doing drvconfig, please wait ... == Doing devlinks, please wait ... == drvconfig and devlinks completed ... == 1 SCI card was detected in the system == Programming SCI card #1 with nodeid, adapter #, and firmware ... == this takes 20 seconds, please wait ... == Programming is done ... Please verify the following information: sciadm $Revision: 2.30 $ DOLPHIN SBus card (SBus2b) found in SBus slot 0 on Board# 0, card slot 0. Adapter number: 0 NodeId: 220 (0xdc) Slot Number: 0 (0x00) System Board Number: 0 (0x00) Card Slot Number: 0 (0x00) Adapter Serial Number: 6269 Fcode Version: Revision: 2.18 Fcode checksum: 0x8906bca8 Basic FPGA checksum: 0xaf0c0c7d Alternative FPGA checksum: 0xaf0c0c7d == Programming done ... remember to reboot the system when finished |
- © 2010, Oracle Corporation and/or its affiliates