To access the Addressing parameters window from x25tool, click on the Addressing button in the Link Editor window. The parameter values are stored in the link configuration files /etc/opt/SUNWconn/x25/config/link_config_nnnn.cfg, where nnnn is the four-digit number that indicates the link number (for example, the file link_config_0004.cfg contains the parameters for link number 4).
Choose None (the default), OSI, or non-OSI. This is the type of extended address you use in the network to which the link you are configuring is attached. Not available for WAN (1980) link types.
Enter a hexadecimal address of 40 digits or fewer. Not available for WAN (1980) link types.
The following parameters apply to LAN addresses, only.
This applies to LAN connections, only. It is a one-byte (two-hexadecimal-digit) address. The default of 7e is the standard SAP for LLC2 under X.25.
This applies to LAN connections only. It is a one-byte (two-hexadecimal-digit) address. The default of 70 is the standard loopback SAP for LLC2.
It is the maximum number of simultaneous connections to be made over this link.