Change one or more existing VRRP interfaces.
config
vSwitch-name vRouter-name vrrp interface ifName IfName vrid integer
| Field Name | Description |
|---|---|
| ipAddresses ipAddress | Specifies one or more VRRP IP addresses. These addresses cannot be IP addresses associated with a vRouter IP interface. |
| primaryIpAddress ipAddress |
Optional: Defines the IP address that the VRRP router uses to transmit VRRP advertisements when it is the master VRRP router. This address is an IP address associated with a vRouter IP interface. One of the following occurs when you use the default value: If the vRouter interface has only one IP address, VRRP uses that address as the primary IP address. If the vRouter interface has multiple IP addresses, VRRP uses the lowest IP address as the primary IP address. The default setting is "0.0.0.0". |
| adminState enumeration |
Optional: Specifies the administrative state of VRRP on the vRouter. If enabled, the Sun Secure Application Switch vRouter participates as a VRRP router. If disabled, the vRouter does not participate as a VRRP router. The default setting is "disabled". Valid values:
enabled, disabled
|
| priority integer |
Optional: Specifies the priority value of the VRRP router. The higher the value, the higher the priority. Valid values are from 1 to 254; the default setting is "100". |
| interval integer |
Optional: The advertisement interval indicates the time interval in seconds between advertisements. Valid values are from 1 to 255; the default setting is "1". |
| preempt enumeration |
Optional: Controls whether a backup VRRP router with a higher priority can preempt a lower priority master VRRP router. If set to true, the preemption can occur. If set to false, the backup VRRP router cannot preempt a master VRRP router with a lower priority. The default setting is "true". Valid values:
true, false
|
| icmpEcho enumeration |
Optional: Indicates whether the virtual router will respond to ICMP echo requests. An RFC compliant VRRP router will not respond to ICMP echo requests unless it is the owner of the IP address. This field overrides the RFC requirement. The default setting is "disabled". Valid values:
enabled, disabled
|