Replacing the Key Switch Assembly

1. Gently insert the key switch assembly in the enclosure.

   Viewed from the front of the system, the key switch assembly is on the right side of the enclosure (Figure E-16).

   ---

   Caution -

   DO NOT FORCE the key switch assembly into the slot; this can cause damage to the key switch assembly and system.

   ---

   The key switch assembly should insert and seat smoothly. If it binds, remove it, and inspect the slot for any obvious obstructions. Do not damage the springfingers at the bottom of the key switch assembly.

2. Tighten the two captive screws securing the key switch assembly to the enclosure.

3. Tilt the top bezel at a 45^o angle and insert the lip of the bezel under the top of the enclosure (Figure E-15).

4. Lower the top bezel.

   The top bezel should snap into place.

5. Replace the system key.

6. Power on the Enterprise system.

   See the power on instructions in Chapter 11, Powering Off and On .