Each SBus+ and Graphics+ I/O board has two onboard connectors; each connector accommodates one GBIC (100 MB/sec Fibre Channel).
Locate the GBIC to be removed (Figure 4-23 or Figure 4-24).
Remove the GBIC from the I/O+ board by compressing the locking tabs located on either side of the card and pulling straight out from the opening in the I/O+ board panel (Figure 4-25).
Locate the GBIC slot for installation (Figure 4-24).
Ensure correct orientation for insertion.
The alignment slots should be on the bottom of the GBIC (Figure 4-25).
Insert the GBIC into the I/O+ board panel slot and then push in to firmly seat the card.
An audible click indicates the GBIC is properly seated to the onboard connector.