The following options are available to save and restore your system configuration:
Eject diskette. This option ejects a diskette from the drive. If you save or restore your system configuration to or from a diskette, the diskette is ejected at the end of the operation.
Save configuration to diskette. This option saves your current system configuration to the diskette in the drive. If you use an unformatted diskette, it is formatted as part of the save process.
Save configuration to file system. This option saves your current system configuration to a system hard disk.
Restore configuration from diskette. Either all or selected configurations on the diskette are restored to the Netra system. This option is displayed only if there is a valid Netra system configuration on the diskette.
Restore configuration from file system. Either all or selected configurations on the hard disk are restored to the Netra system. This option is displayed only if there is a valid Netra system configuration on the hard disk.
Table 6-10 describes when file system options are displayed on the Netra j 2.0 Main Administration page.
Table 6-10 Options Displayed
Option |
When the Option is Displayed on the Main Administration Page |
---|---|
Eject Diskette |
The diskette is in the disk drive. |
Save Configuration to Diskette |
The diskette is in the disk drive. |
Restore Configuration from Diskette |
The diskette in the disk drive contains valid Netra configuration information. |
Restore Configuration from File System |
The Netra configuration state has previously been saved to a file on the hard disk. |
If you are saving to diskette, insert the diskette into the drive; otherwise, proceed to Step 2.
Make sure the diskette is not write-protected.
From the Main Administration page, under "System Administration," click Save and Restore Configuration
The Save and Restore Configuration Administration page is displayed.
Click either Save configuration to diskette or Save configuration to file system; then confirm the operation.
If you are restoring the configuration from a diskette, insert a diskette into the drive; otherwise, proceed to Step 2.
From the Main Administration page, under "System Administration," click Save and Restore Configuration
The Save And Restore Configuration Administration page is displayed.
Click either Restore configuration from diskette or Restore configuration from file system.
Complete the form using the information in Table 6-11.
Table 6-11 Save/Restore Configuration
Option |
Description |
---|---|
Restore entire configuration |
Restores all configurations from the diskette/disk. |
Restore selected configurations |
Restores only the selected configurations from the diskette/disk. If you select this option, you must also select at least one configuration; if you select any configurations, you must also select this option. |