To Manually Set an SSC IP Address, Netmask, and Gateway

Steps

1. Use telnet to access the chassis SSC.

2. To set up the SSC, type setupsc.

   The following messages appear.

   Entering Interactive setup mode. Use Ctrl-z to exit & save. Use Ctrl-c to abort Do you want to configure the enabled interfaces [y]?

3. Type y to configure the SSC.

   You are prompted in succession for each SSC configuration value. The default values are shown in brackets ([]).

   The default values for the SSC IP address, netmask, and gateway are as follows.

   Enter the SC IP address [10.5.132.65]: Enter the SC IP netmask [255.255.255.0]: Enter the SC IP gateway [10.5.132.1]:

   Type the address if your chosen address is different, or press Enter to accept the default.