This task enables you to configure the NET MGT interface.
Note - The following procedure makes changes that do not require a reset or reboot.
-> set /SP/network property=value property=value ...
property is the parameter of the network to configure.
value is the value of the property to configure.
The following properties are supported:
pendingipaddress – The value is the IP address of the management controller to be configured.
pendingipdiscovery – The value is the method of IP discovery to be configured, either static or dhcp.
pendingipgateway – The value is the IP address of the gateway to be configured.
pendingipnetmask – The value is the netmask to be configured.
Note - You can configure one, several, or all properties in one command line.
-> set /SP/network commitpending=true
For example, to set the IP address of the management controller:
-> show /SP/network ipaddress /SP/network Properties: ipaddress = 188.8.131.52 -> set /SP/network pendingipaddress=184.108.40.206 Set ’pendingipaddress’ to ’220.127.116.11’ -> set /SP/network commitpending=true Set ’commitpending’ to ’true’
The IP address has changed to 18.104.22.168.
Note - Changing some network management properties terminates the NET MGT connection to the management controller. You must re-establish the connection to continue administering the management controller. See Accessing Oracle ILOM From the CLI.
-> show /SP/network ipaddress /SP/network Properties: ipaddress = 22.214.171.124 ->