Sun Studio 12: Debugging a Program With dbx

ProcedureRunning the Sample dbx Session

  1. Compile and link with the- g option.

    You can do this in one or two steps.

    Compile and link in one step, with -g:

     demo% f95 -o my_program -g a1.f a2.f a3.f

    Or, compile and link in separate steps:

     demo% f95 -c -g a1.f a2.f a3.f
     demo% f95 -o my_program a1.o a2.o a3.o
  2. Start dbx on the executable named my_program.

     demo% dbx my_program
     Reading symbolic information…
  3. Set a simple breakpoint by typing stop in subnam, where subnam names a subroutine, function, or block data subprogram.

    To stop at the first executable statement in a main program.

     (dbx) stop in MAIN
     (2) stop in MAIN

    Although MAIN must be all uppercase, subnam can be uppercase or lowercase.

  4. Type the run command, which runs the program in the executable files named when you started dbx.

     (dbx) run
     Running: my_program
     stopped in MAIN at line 3 in file "a1.f"
         3         call mkidentity( twobytwo, n )

    When the breakpoint is reached, dbx displays a message showing where it stopped—in this case, at line 3 of the a1.f file.

  5. To print a value, type the print command.

    Print value of n:

     (dbx) print n
     n = 2

    Print the matrix twobytwo; the format might vary:

     (dbx) print twobytwo
     twobytwo =
        (1,1)       -1.0
        (2,1)       -1.0
        (1,2)       -1.0
        (2,2)       -1.0

    Print the matrix array:

    (dbx) print array
    dbx: "array" is not defined in the current scope

    The print fails because array is not defined here—only in mkidentity.

  6. To advance execution to the next line, type the next command.

    Advance execution to the next line:

    (dbx) next
    stopped in MAIN at line 4 in file "a1.f"
        4             print *, determinant( twobytwo )
    (dbx) print twobytwo
    twobytwo =
        (1,1)       1.0
        (2,1)       0.0
        (1,2)       0.0
        (2,2)       1.0
    (dbx) quit

    The next command executes the current source line and stops at the next line. It counts subprogram calls as single statements.

    Compare the next command with the step command. The step command executes the next source line or the next step into a subprogram. If the next executable source statement is a subroutine or function call, then:

    • The step command sets a breakpoint at the first source statement of the subprogram.

    • The nextcommand sets the breakpoint at the first source statement after the call, but still in the calling program.

  7. To quit dbx, type the quit command.