c must be one of the following values.
Table A–25 The -xcache Values
Value |
Meaning |
---|---|
generic |
This is the default value which directs the compiler to use cache properties for good performance on most x86 and SPARC processors, without major performance degradation on any of them. With each new release, these best timing properties will be adjusted, if appropriate. |
native |
Set the parameters for the best performance on the host environment. |
s1/l1/a1[/t1] |
Defines level 1 cache properties |
s1/l1/a1[/t1]:s2/l2/a2[/t2] |
Defines level 1 and 2 cache properties |
s1/l1/a1[/t1]:s2/l2/a2[/t2]:s3/l3/a3[/t3] |
Defines level 1, 2, and 3 cache properties |
The definitions of the cache properties si/li/ai/ti are as follows:
Property |
Definition |
---|---|
si |
The size of the data cache at level i, in kilobytes |
li |
The line size of the data cache at level i, in bytes |
ai |
The associativity of the data cache at level i |
For example, i=1 designates level 1 cache properties, s1/l1/a1.
If –xcache is not specified, the default –xcache=generic is assumed. This value directs the compiler to use cache properties for good performance on most SPARC processors, without major performance degradation on any of them.
If you do not specify a value for t, the default is 1.
–xcache=16/32/4:1024/32/1 specifies the following:
Level 1 Cache Has |
Level 2 Cache Has |
---|---|
16 Kbytes |
1024 Kbytes |
32 bytes line size |
32 bytes line size |
4-way associativity |
Direct mapping associativity |
–xtarget=t