If you have determined that launching semi-auto failover is appropriate for a particular error, set the following task arguments. (The on-error workflow must launch the Active Directory Synchronization failover task.) Setting these arguments reconfigures the failed resource and the IAPI Object to use an alternate domain controller and usnChanged starting point.
Argument |
Description |
---|---|
resourceName |
Identifies (by name or resource ID) where the failure has occurred. |
autoFailover |
Specifies whether auto failure is set. Must be set to true. |
failureTimestamp |
Indicates when the failure occurred. This value is derived from the onSync failure process. |
replicationTime |
Specifies the maximum time in hours for data to replicate across an Active Directory environment. |
To manually specify which domain controller to fail over to and which saved HighestCommittedUSN number to start from, set the following arguments.
Argument |
Description |
---|---|
resourceName |
Specifies the name or ID of the resource where the failure has occurred. |
backupDC |
Specifies the name of the host with which to begin the synchronization process. |
usnDate |
The timestamp to use that correlates to a collected HighestCommittedUSN changed value from the collected data. This would be computed just as targetTime was computed in the semi-auto mode. |
restartActiveSync |
Specifies whether to start Active Sync after the switch to the new domain controller is complete. |