SPARC: 如何连接 SCSI 控制器

以下过程在连接 SCSI 控制器的示例中使用 SCSI 控制器 c1。

1. 成为超级用户。

2. 验证连接设备之前该设备是否已断开连接。

   # cfgadm -al Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 disk connected configured unknown c0::rmt/0 tape connected configured unknown c1 unavailable disconnected configured unknown c1::dsk/c1t3d0 unavailable disconnected configured unknown c1::dsk/c1t4d0 unavailable disconnected configured unknown

3. 连接 SCSI 控制器。

   # cfgadm -c connect c1

4. 验证 SCSI 控制器是否已连接。

   # cfgadm -al Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 disk connected configured unknown c0::rmt/0 tape connected configured unknown c1 scsi-bus connected configured unknown c1::dsk/c1t3d0 disk connected configured unknown c1::dsk/c1t4d0 disk connected configured unknown