After processing the registration, the server sends the SC_REPLY message. The server sends this message on the open TCP connection from the client on which the server received the registration request. The server then closes the connection. The client must keep the TCP connection open until it receives the SC_REPLY message from the server.
For example, the client carries out the following actions:
Opens a TCP connection to the server
Waits for a connection to be “writeable”
Sends an SC_CALLBACK_REG message (which contains an ADD_CLIENT message)
Waits for an SC_REPLY message
Receives an SC_REPLY message
Receives an indicator that the server has closed the connection (reads 0 bytes from the socket)
Closes the connection
Opens a TCP connection to the server
Waits for a connection to be “writeable”
Sends an SC_CALLBACK_REG message (which contains a REMOVE_CLIENT message)
Waits for an SC_REPLY message
Receives an SC_REPLY message
Receives an indicator that the server has closed the connection (reads 0 bytes from the socket)
Closes the connection
Each time that the server receives an SC_CALLBACK_REG message from a client, the server sends an SC_REPLY message on the same open connection. This message specifies whether the operation succeeded or failed. SC_REPLY XML DTD contains the XML document type definition of an SC_REPLY message, and the possible error messages that this message can include.
An SC_REPLY message specifies whether an operation succeeded or failed. This message contains the version of the CRNP protocol message, a status code, and a status message, which describes the status code in more detail. The following table describes the possible values for the status code.
Status Code |
Description |
---|---|
OK |
The message was processed successfully. |
RETRY |
The registration of the client was rejected by the server due to a transient error (the client should try to register again, with different parameters). |
LOW_RESOURCE |
Cluster resources are low, and the client can only try again at a later time (the system administrator for the cluster can also increase the resources on the cluster). |
SYSTEM_ERROR |
A serious problem occurred. Contact the system administrator for the cluster. |
FAIL |
Authorization failed or another problem caused the registration to fail. |
MALFORMED |
The XML request was malformed and could not be parsed. |
INVALID |
The XML request was invalid (does not meet the XML specification). |
VERSION_TOO_HIGH |
The version of the message was too high to process the message successfully. |
VERSION_TOO_LOW |
The version of the message was too low to process the message successfully. |
Under normal conditions, a client that sends an SC_CALLBACK_REG message receives a reply that indicates that the registration succeeded or failed.
However, the server can experience an error condition when a client is registering that prohibits the server from sending an SC_REPLY message to the client. In this case, the registration could either have succeeded before the error condition occurred, could have failed, or could not yet have been processed.
Because the server must function as a failover, or highly available, server on the cluster, this error condition does not mean an end to the service. In fact, the server could soon begin sending events to the newly registered client.
To remedy these conditions, your client should both:
Impose an application-level time-out on a registration connection that is waiting for an SC_REPLY message, after which the client needs to retry registering.
Begin listening on its callback IP address and port number for event deliveries before it registers for the event callbacks. The client should wait for a registration confirmation message and for event deliveries in parallel. If the client begins to receive events before the client receives a confirmation message, the client should silently close the registration connection.