The following example shows the root (/) file system restored to the node phys-schost-1 from the tape device /dev/rmt/0. The metaset command is run from another node in the cluster, phys-schost-2, to remove and later add back node phys-schost-1 to the metaset schost-1. All other commands are run from phys-schost-1. A new boot block is created on /dev/rdsk/c0t0d0s0, and three state database replicas are recreated on /dev/rdsk/c0t0d0s4.
[Become superuser on a cluster node with access to the metaset, other than the node to be restored.] [Remove the node from the metaset:] phys-schost-2# metaset -s schost-1 -f -d -h phys-schost-1 [Replace the failed disk and boot the node:] |
Boot the node from the Solaris CD:
SPARC: At the OpenBoot PROM ok prompt, type the following command:
ok boot cdrom -s |
x86: Insert the CD into the system's CD drive and boot the system by shutting it down and then turning it off and on. On the Current Boot Parameters screen, type the following command:
<<< Current Boot Parameters >>> Boot path: /pci@0,0/pci8086,2545@3/pci8086,1460@1d/pci8086,341a@7,1/ sd@0,0:a Boot args: Type b [file-name] [boot-flags] <ENTER> to boot with options or i <ENTER> to enter boot interpreter or <ENTER> to boot with defaults <<< timeout in 5 seconds >>> Select (b)oot or (i)nterpreter: b -s |
[Use format and newfs to recreate partitions and file systems.] [Mount the root file system on a temporary mount point:] # mount /dev/dsk/c0t0d0s0 /a [Restore the root file system:] # cd /a # ufsrestore rvf /dev/rmt/0 # rm restoresymtable [Install a new boot block:] # /usr/sbin/installboot /usr/platform/`uname \ -i`/lib/fs/ufs/bootblk /dev/rdsk/c0t0d0s0 [Remove the lines in /temp-mountpoint/etc/system file for MDD root information:] * Begin MDD root info (do not edit) forceload: misc/md_trans forceload: misc/md_raid forceload: misc/md_mirror forceload: misc/md_hotspares forceload: misc/md_stripe forceload: drv/pcipsy forceload: drv/glm forceload: drv/sd rootdev:/pseudo/md@0:0,10,blk * End MDD root info (do not edit) [Edit the /temp-mountpoint/etc/vfstabfile] Example: Change from— /dev/md/dsk/d10 /dev/md/rdsk/d10 / ufs 1 no - Change to— /dev/dsk/c0t0d0s0 /dev/rdsk/c0t0d0s0 /usr ufs 1 no - [Unmount the temporary file system and check the raw disk device:] # cd / # umount /a # fsck /dev/rdsk/c0t0d0s0 [Reboot in single-user mode:] # reboot -- "-s" [Replace the disk ID:] # scdidadm -R /dev/dsk/c0t0d0 [Recreate state database replicas:] # metadb -c 3 -af /dev/rdsk/c0t0d0s4 # reboot Type Control-d to boot into multiuser mode. [Add the node back to the metaset:] phys-schost-2# metaset -s schost-1 -a -h phys-schost-1 |