read
|
Read each sector on this disk. Repairs
defective blocks as a default.
|
refresh
|
Read then write data on the disk without
harming the data. Repairs defective blocks as a default.
|
test
|
Write a set of patterns to the disk
without harming the data. Repairs defective blocks as a default.
|
write
|
Write a set of patterns to the disk
then read the data on the disk back. Destroys existing data on the disk. Repairs
defective blocks as a default.
|
compare
|
Write a set of patterns to the disk,
read the data back, and compare it to the data in the write buffer. Destroys
existing data on the disk. Repairs defective blocks as a default.
|
purge
|
Remove all data from the disk so that
the data can't be retrieved by any means. Data is removed by writing three
distinct patterns over the entire disk (or section of the disk), then writing
an hex-bit pattern if the verification passes.
Repairs defective
blocks as a default.
|
verify
|
Write unique data to each block on
the entire disk in the first pass. Read and verify the data in the next pass.
Destroys existing data on the disk. Repairs defective blocks as a default.
|
print
|
View the data in the read/write buffer.
|
setup
|
Specify the following analysis parameters
Analyze entire disk? yes
Starting block number: depends on drive
Ending block number: depends on drive
Loop continuously? no
Number of passes: 2
Repair defective blocks? yes
Stop after first error? no
Use random bit patterns? no
Number of blocks per transfer: 126 (0/n/nn)
Verify media after formatting? yes
Enable extended messages? no
Restore defect list? yes
Restore disk label? yes
Defaults
are shown in bold.
|
config
|
View the current analysis parameters.
|
quit
|
Exit the analyze
menu.
|