Adaptec AHA-2940, 2940W, 2944W, 3940, 3940W HBAs

Solaris Device Driver:	`adp`
Device Type:	SCSI-2
Adapters:	Adaptec AHA-2940, AHA-2940W, AHA-2944W, AHA-3940, AHA-3940W
Chips:	Adaptec AIC-7850, AIC-7860, AIC-7870, AIC-7880, AIC-7895
Bus Type:	PCI

Preconfiguration Information

The Plug N Play SCAM Support option is not supported.

To use the AHA-3940 or AHA-3940W adapters, the motherboard must have a BIOS that supports the DEC PCI-to-PCI Bridge chip on the host bus adapter.
User-level programs have exhibited problems on some PCI systems with an Adaptec AHA-2940 or AHA-2940W card, including the following motherboard models:
- PCI motherboards with a 60-MHz Pentium chip, with PCI chipset numbers S82433LX Z852 and S82434LX Z850. The part numbers of the Intel motherboards are AA616393-007 and AA615988-009.
- PCI motherboards with a 90-MHz Pentium chip, with PCI chipset numbers S82433NX Z895, S82434NX Z895, and S82434NX Z896. The part number of the Intel motherboard is 541286-005. (Some Gateway 2000 systems use this motherboard.)
- The AA-619772-002 motherboard with 82433LX Z852 and 82434LX Z882 chips causes random memory inconsistencies. Return the motherboard to the vendor for a replacement.
If problems with user-level programs occur, use the BIOS setup to turn off write-back CPU caching (or all caching if there is no control over the caching algorithm).
If the AHA-2940 SCSI adapter does not recognize the Quantum Empire 1080S HP 3323 SE or other SCSI disk drive, reduce the Synchronous Transfer rate on the Adaptec controller to 8 Mbps.
The AHA-3940 has been certified by Adaptec to work on specific systems; however, some testing has shown that the Solaris operating environment works properly in some of those systems and not in others.

Using the Adaptec configuration utility:

Configure each SCSI device to have a unique SCSI ID, and on the adapter's Advanced Configuration Options setup menu, set the Plug N Play SCAM Support option to Disabled.
If there is more than one controller (or an embedded controller), try to use one IRQ per controller.
Enable bus mastering for the slots with your host bus adapters, when the choice is given.
For older disk drives, tape drives, and most CD-ROM devices, make sure the maximum SCSI data transfer speed is set to 5.0 Mbps.
Enable support for disks larger than 1 Gbyte if applicable.