To Configure the Initial Diameter Service

To create the Diameter service, you must use the command line. If you do not specify the target operand, the default instance is used. If the task applies to a cluster, target must specify the cluster name.

After you create the Diameter service by using the create-diameter-service command, the Diameter node appears in the Communications Server Admin Console.

Before You Begin

The Diameter Adapter must be installed before Diameter can be configured.

1. Create the Diameter service by using the create-diameter-service(1) command.

   asadmin> create-diameter-service target-name

   Default target-name is server.

2. Repeat Step 1 for each additional configuration.

   This is a one-time task per configuration.

3. Create a Diameter application by using the create-diameter-application(1) command.

   For additional usage information, see To Create a Diameter Application.

4. Create a Diameter peer by using the create-diameter-peer(1) command.

   For additional usage information, see To Create a Diameter Peer.

5. Restart the server for changes to take effect.

   Use the stop-domain(1) and start-domain(1) commands.