Sun Cluster System Administration Guide for Solaris OS

ProcedureHow to Print Faulted Disk Paths

Use the following procedure to print the faulted disk paths for a cluster.

Caution – Caution –

DPM is not supported on nodes that run versions that were released prior to Sun Cluster 3.1 10/03 software. Do not use DPM commands while a rolling upgrade is in progress. After all nodes are upgraded, the nodes must be online to use DPM commands.

  1. Become superuser on any node in the cluster.

  2. Print the faulted disk paths throughout the cluster.

    # scdpm -p -F node:disk path

    Refer to Table 4–5 for naming conventions for the node:disk path argument.

Example 4–24 Printing Faulted Disk Paths

The following example prints faulted disk paths for the entire cluster.

# scdpm -p -F [all:]all
		 schost-1:/dev/did/dsk/d4   Fail
	     schost-1:/dev/did/dsk/d3   Fail
	     schost-2:/dev/did/dsk/d4   Fail
	     schost-2:/dev/did/dsk/d3   Fail
	     schost-2:/dev/did/dsk/d5   Fail
	     schost-2:/dev/did/dsk/d6   Fail