Skip Navigation Links | |
Exit Print View | |
Sun Blade 6000 Virtualized Multi-Fabric 10GbE M2 Network Express Module Product Notes Sun Blade 6000 Virtualized Multi-Fabric 10GbE M2 Network Express Module Documentation Library |
About This Documentation (PDF and HTML)
Overview of the Sun Blade 6000 Virtualized Multi-Fabric 10GbE M2 NEM Product Notes
Supported Software and Firmware
Hardware and Networking Issues
Packet Drop at 1Gb with 100m Cable (6879222)
Special Instructions for Network PXE Booting for the Sun Blade X3-2B Server (7183913)
ILOM Failover and Private Mode Cannot Be Enabled Simultaneously (6911661)
Cannot Set NEM SP IP Address When NEM Is Powered Off (6938660)
ipmitool Command Fails (6940791)
Prepare-to-Remove and Return-to-Service Does Not Work on NEM ILOM (6948103)
Green Rear SAS Link LEDs All Turn On When Setting Prepare-to-Remove (6950981)
NEM SAS Firmware Updates Must be Performed from the CMM and Not the NEM SP (7020854)
Oracle Linux: Server Module Might Hang When NEM Replaced Repeatedly (6935520)
Linux: Configuring PCIe Hot Plug in Linux (7075694)
Windows: Incorrect Driver Version Displayed When Driver File Properties is Viewed (7069358)
In Oracle Solaris, the Virtualized M2 NEM hxge devices can become unpingable and hxge entries can disappear from the arp table under high stress conditions (such as during jumbo maxq payload testing). The arp table does not get updated with the hxge entry even after a ping is issued.
The workaround is to manually add the hxge 10 GbE interface into arp table or, if necessary, reboot the blade server.
arp -s <hxge_ipaddress> <mac_address>
Repeat the command for each hxge interface.