/opt/SUNWvts/bin/atmtest standard_arguments -o dev=device,tpkts=n,nv=n,ml=n,bw=n,opkts=n,ld,sd,sl,nc,ns,vcf
Table 3-2 atmtest Command Line Syntax
Argument |
Explanation |
---|---|
dev=device |
Specifies the device name to be tested, such as ba0 or sa0. |
tpkts=n |
Specifies the number of packets to loopback [1.2147483647]. |
nv=num_vc |
Specifies the number of simultaneous virtual circuits to be tested. |
ml=max_len |
Specifies the maximum length of the random packet. |
bw=bandwidth |
Specifies the bandwidth in MBits/s of a virtual circuit. |
opkts=n |
Specifies the number of packets for each virtual circuit that can be transmitted without receiving a corresponding packet. |
lb |
The internal loopback mode is selected. |
sd |
Changes the payload data to static instead of random. |
sl |
Changes all packets to their maximum length. |
nc |
Instructs the test not to check the receive payload (Improves throughput). |
ns |
Instructs the test not to exit on a packet reception failure. |
vcf=n |
Specifies the first virtual circuit number used. |
64-bit tests are located in the sparcv9 subdirectory: /opt/SUNWvts/bin/sparcv9/testname. If the test is not present in this directory, then it may only be available as a 32-bit test. For more information refer to "32-Bit and 64-Bit Tests".