gemtest Error Messages
Table 18-3 gemtest Error Messages|
|
Error Message |
Probable Cause(s) |
Recommended Action |
|---|---|---|---|
| 6000 | Timed out for receiving pkt number | Card and/or driver not configured properly. | Configure driver or reseat card. Check loopback connector. If the problem persists, contact your authorized Sun service Provider. |
| 6001 | system error | System may have run out of memory. | Reduce the number of processes currently running or increase system memory. |
| 6002 | Data mismatch between transmitted and received pkt data | Link loss,CRC error,Alignment Error. | If the frequency of errors is large, replace the card and/or contact your authorized Sun service Provider. |
| 8000 | errmsg for device | Card not present | Check for card. |
| 8001 | Memory allocation failure | System ran out of memory. | Reduce the number of processes currently running. Increase system memory. |
| 8002 | No card found | No card found. | Install card. |
| 8003 | Failed to get the link up | Loopback connector not connected. | Faulty loopback connector. Check it an replace it if necessary. If problem persists, contact your authorized Sun service Provider |
| 8004 | Transmit failed error | STREAMS was unable to accept more data, perhaps due to insufficient STREAMS memory resources. | Reduce the system load. |
| 8005 | Receive failed, error for pkt number | Try again, if the problem persists, then it is a system error. Contact your authorized Sun service provider. | |
| 8006 | DLPI error for device string | Wrong Instance number X specified in geX | Specify correct instance number. |
- © 2010, Oracle Corporation and/or its affiliates