pstest Error Messages

6001

Checking prstatus failed:

6002

Failed to turn prestoserve DOWN:

6003

File I/O test failed with low performance ratio: number

Check that Prestoserve is configured for /tmp.

6004

byte compare: location = address, observed = number, expected = number

6005

word compare: location = address, observed = number, expected =number

6006

(data type) long compare: location = address, observed = number, expected = number

6007

lseek() failed:

6008

NVRAM write failed:

6009

NVRAM read failed:

6010

Failed to get status of Prestoserve failed:

6011

Failed to reinitialize Prestoserve:

6012

Failed to turn prestoserve UP:

6013

Failed to munmap prestoserve:

6014

File write failed:

6015

File read failed:

6016

Data compare failed

6017

Failed to restore prestoserve state: %s

6018

Prestoserve test is applicable in Functional test only

8001

Failed to open prestoserve board:

Prestoserve hardware not installed. 

NVSIMM/NVRAM SBus board not seated correctly. 

Prestoserve software not installed. 

Not in superuser mode. 

8002

Prestoserve is in the ERROR state

Errors occurred on a disk drive. 

8003

Some batteries are not good or not enabled

8004

memory_check (pass pass_id) failed

8005

fileio_check (pass pass_id) failed

8006

File I/O test failed (Prestoserve down)

8007

File I/O test failed (Prestoserve up)

8008

Open %s also failed: %s. Please enter test file directory

8009

PRESTOSERVE TESTS FAILED!