|
Error Message |
Probable Cause(s) |
Recommended Action |
---|---|---|---|
6000 |
Missing device name |
No device name is specified. |
Retry test with correct device name specification. |
6001 |
failed ioctl on unload and load next tape: err_code = number! |
This stacker/library unit may lack the Automatic Cycle option. |
Run the test with Single Pass Option enabled. |
6002 |
Cannot open device_name: error_message |
No tape media in drive. |
Load tape media and retry test. |
6005 |
Cannot close device_name: error_message |
Bad drive. |
Retry test; if problem persists, check or replace the drive. |
6006 |
text write failed on error_message, block number: EOF reached |
EOF reached prematurely. |
Retry test with reduced blocksize specification or until EOF. |
6007 |
text write failed on device_name, block number: error_message, sense key(0xvalue) = text |
Drive needs attention. |
Perform action to reset sense key and retry the test. |
6008 |
text read failed on device_name, block number: EOF reached |
EOF reached prematurely. |
Retry test with reduced blocksize specification or until EOF. |
6009 |
text read failed on device_name, block number: error_message, sense key(0xvalue) = text |
Drive needs attention. |
Perform action to reset sense key and retry test. |
6010 |
text compare failed on device_name, block number, offset number, pattern 0xvalue, data= 0xvalue |
Bad drive. |
Retry test; if problem persists, check or replace the drive. |
6011 |
device_name tape MTIOCGETDRIVETYPE ioctl: number |
Bad drive. |
Retry test; if problem persists, check or replace the drive. |
6012 |
text failed on device_name: error_message |
Bad drive. |
Retry test; if problem persists, check or replace the drive. |
6013 |
Failed Connection test on device_name:error_message |
Broken cable. |
Check or replace the cable. |
Bad drive. |
Check or replace the drive. |
||
6014 |
Failed Online test:device_name |
Device may be in use. |
Retry later. |
6015 |
Failed Online test:device_name:error_message |
No tape media in drive. |
Load tape media and retry test. |
6016 |
Online test was unsuccessful:device_name |
No tape media in drive. |
Load tape media and retry test. |
6017 |
Failed Online read test:device_name |
Bad drive. |
Retry test; if problem persists, check or replace the drive. |
6018 |
Open Failed on device_name: error_message |
Broken cable. |
Check or replace the cable. |
Bad drive. |
Check or replace the drive. |
||
6018 |
recon: No Corresponding SCSI disk device |
|
|
6019 |
Needs both SCSI disk and SCSI tape to run the test |
|
|
6020 |
Couldn't retension 'device_name' |
|
|
6021 |
Couldn't read file 'device_name' |
|
|
6022 |
SCSI disconnect/reconnect failed |
|
|
6023 |
Spurious signal received from child |
|
|
2005 |
Tandberg QIC Read/Write media failure. |
Incorrect test settings for older QIC tape media. |
Retry the test and specify a 512-byte blocksize. Retry the test with a read-only setting. Use the highest capacity tape media that the drive will allow (refer to tape drive documentation for QIC media compatibilities.). |