Netra™ High Availability Suite 3.0 1/08 Foundation Services Standalone CGTP GuideTable Of Contents Previous ChapterNext ChapterBook Index


C H A P T E R  3

Installing Standalone CGTP on Linux

This chapter describes how to install the standalone CGTP patches and packages on the Linux operating system.

You must perform the procedures on each node on which you want to use standalone CGTP. Do not perform these procedures on a node on which you are using the Foundation Services. Perform the procedures in the order presented.

Installing the CGTP Package

procedure icon  To Install the CGTP Package

Before installing the CGTP package, you must have installed the Linux kernel that has been modified for use with the Netra HA Suite software. For information about installing the modified Linux kernel, refer to the Netra High Availability Suite 3.0 1/08 Foundation Services Installation Guide.

  1. As superuser, log in to the node on which you want to install standalone CGTP.

  2. Install the CGTP package:


    # rpm -i software-distribution-dir/sun-nhas-cgtp-3.0-*.rpm

    software-distribution-dir is the directory containing the Foundation Services packages.

  3. Verify that the package has been correctly installed:


    # rpm -q sun-nhas-cgtp

    If the installation was successful, you see the following output:


    sun-nhas-cgtp-3.0- build

  4. Reboot the node.


    Note - For information about rebooting a node, see the Netra High Availability Suite 3.0 1/08 Foundation Services Cluster Administration Guide.




Netra™ High Availability Suite 3.0 1/08 Foundation Services Standalone CGTP Guide819-5247-13Table Of Contents Previous ChapterNext ChapterBook Index


Copyright © 2008, Sun Microsystems, Inc. All rights reserved.