SCSI controller c1 provides an example of how to add a SCSI device to a SCSI bus.
When you add devices, you specify the Ap_Id of the SCSI HBA (controller) to which the device is attached, not the Ap_Id of the device itself.
Become superuser.
Identify the current SCSI configuration.
# cfgadm -al Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 disk connected configured unknown c0::rmt/0 tape connected configured unknown c1 scsi-bus connected configured unknown c1::dsk/c1t3d0 disk connected configured unknown |
Add the SCSI device to the SCSI bus.
# cfgadm -x insert_device c1 Adding device to SCSI HBA: /devices/sbus@1f,0/SUNW,fas@1,8800000 This operation will suspend activity on SCSI bus: c1 |
Type y at the Continue (yes/no)? prompt to proceed.
Continue (yes/no)? y SCSI bus quiesced successfully. It is now safe to proceed with hotplug operation. |
I/O activity on the SCSI bus is suspended while the hot-plug operation is in progress.
Connect the device and then power it on.
Type y at the Enter y if operation is complete or n to abort (yes/no)? prompt.
Enter y if operation is complete or n to abort (yes/no)? y |
Verify that the device has been added.
# cfgadm -al Ap_Id Type Receptacle Occupant Condition c0 scsi-bus connected configured unknown c0::dsk/c0t0d0 disk connected configured unknown c0::rmt/0 tape connected configured unknown c1 scsi-bus connected configured unknown c1::dsk/c1t3d0 disk connected configured unknown c1::dsk/c1t4d0 disk connected configured unknown |
A new disk has been added to controller c1.