On a cluster where the Solaris 10 OS is running, you can configure a resource group to run in the global zone or in non-global zones. The RGM manages each zone as a switchover target. If a non-global zone is specified in the node list of a resource group, the RGM brings the resource group online in the specified zone on the node.
Figure 3–8 illustrates the failover of resource groups between zones on Sun Cluster nodes in a two-node cluster. In this example, identical zones are configured on each node to simplify the administration of the cluster.
A failover resource group can fail over to a zone on another node or on the same node. However, if the node fails, the failing over of this resource group to a zone on the same node does not provide high availability. Nonetheless, you might find this failing over of a resource group to a zone on the same node useful in testing or prototyping.
You can configure a scalable resource group (which uses network load balancing) to run in a non-global zone as well. However, do not configure a scalable resource group to run in multiple zones on the same node.
In Sun Cluster commands, you specify a zone by appending the name of the zone to the name of the physical node, and separating them with a colon, for example:
phys-schost-1:zoneA
You can specify a zone with several Sun Cluster commands, for example:
Use support for Solaris zones directly through the RGM if any of following criteria is met:
Your application cannot tolerate the additional failover time that is required to boot a zone.
You require minimum downtime during maintenance.
You require dual-partition software upgrade.
You are configuring a data service that uses a shared address resource for network load balancing.
If you plan to use support for Solaris zones directly through the RGM for an application, ensure that the following requirements are met:
The application is supported to run in non-global zones.
The data service for the application is supported to run in non-global zones.
If you use support for Solaris zones directly through the RGM, configure resources and resource groups as follows:
Ensure that resource groups that are related by an affinity are configured to run in the same zone. An affinity between resource groups that are configured to run in different zones on the same node has no effect.
Configure every application in the non-global zone as a resource.
For information about how to configure support for Solaris zones directly through the RGM, see the following documentation: