test

Sun Cluster Data Service for Oracle E-Business Suite Guide for Solaris OS

Debugging Sun Cluster HA for Oracle E-Business Suite

ProcedureHow to Turn on Debugging for Sun Cluster HA for Oracle E-Business Suite

Sun Cluster HA for Oracle E-Business Suite can be used by multiple Oracle E-Business Suite instances. It is possible to turn debugging on for all Oracle E-Business Suite instances or a particular Oracle E-Business Suite instance.

/opt/SUNWscebs/xxx/etc/config allows you to turn on debugging for all Oracle E-Business Suite instances or for a specific Oracle E-Business Suite instance on a particular node or zone within the cluster. If you require debugging to be turned on for Sun Cluster HA for Oracle E-Business Suite across the whole cluster, repeat this step on all nodes within the cluster.

  1. Edit the /etc/syslog.conf file and change daemon.notice to daemon.debug. 


    # grep daemon /etc/syslog.conf
*.err;kern.debug;daemon.notice;mail.crit        /var/adm/messages
*.alert;kern.err;daemon.err                     operator
#

    Change the daemon.notice file to daemon.debug and restart the syslogd command. Note that the following output, from grep daemon /etc/syslog.conf, shows that daemon.debug has been set.


    # grep daemon /etc/syslog.conf
*.err;kern.debug;daemon.debug;mail.crit        /var/adm/messages
*.alert;kern.err;daemon.err                    operator

    Restart the syslog daemon.

    • If you are running Solaris 9, type:


      # pkill -1 syslogd

    • If you are running Solaris 10, type:


      # svcadm disable system-log
# svcadm enable system-log

  2. Edit the /opt/SUNWscebs/cmg/etc/config file.

    Perform this step for each component that requires debug output, on each node of Sun Cluster as required.

    Edit the /opt/SUNWscebs/cmg/etc/config file and change DEBUG= to DEBUG=ALL or DEBUG=sun-cluster-resource.


    # cat /opt/SUNWscebs/cmg/etc/config
#
# Copyright 2006 Sun Microsystems, Inc.  All rights reserved.
# Use is subject to license terms.
#
# ident "@(#)config     1.1     06/03/06 SMI"
#
# Usage:
#       DEBUG=<RESOURCE_NAME> or ALL
#
DEBUG=ALL
    Note –

    To turn off debug, reverse the previous steps.