test

Sun Cluster Data Service for Samba Guide for Solaris OS

ProcedureExample: Prepare the Cluster for Samba

  1. Install and configure the cluster as instructed in Sun Cluster Software Installation Guide for Solaris OS.

    Install the following cluster software components on node Vigor5.

    • Sun Cluster core software

    • Sun Cluster data service for Samba

  2. Add the logical host name to /etc/hosts and /etc/inet/ipnodes on the HA container.


    Vigor5# zlogin failover grep SMB1 /etc/hosts /etc/inet/ipnodes
/etc/hosts:192.168.1.132	SMB1#20
/etc/inet/ipnodes:192.168.1.132	SMB1#20

  3. Install and configure a Zettabyte File System.

    Note –

    The following zpool definition represents a very basic configuration for deployment on a single-node cluster.

    You should not consider this example for use within a productive deployment, instead it is a very basic configuration for testing or development purposes only.

    1. Create a ZFS pool.


      Vigor5# zpool create -m /local HAZpool c1t1d0

    2. Create a ZFS.


      Vigor5# zfs create HAZpool/samba

  4. Install and Configure a Solaris Volume Manager File System.

    Note –

    The following metaset definitions represent a very basic configuration for deployment on a single-node cluster.

    You should not consider this example for use within a productive deployment, instead it is a very basic configuration for testing or development purposes only.

    1. Create a SVM Disk Set.


      Vigor5# metaset -s dg_d1 -a -h Vigor5

    2. Add a Disk to the SVM Disk Set.


      Vigor5# metaset -s dg_d1 -a /dev/did/rdsk/d4

    3. Add the Disk Information to the metainit utility input file.


      Vigor5# cat >> /etc/lvm/md.tab <<-EOF
dg_d1/d100      -m      dg_d1/d110
dg_d1/d110      1 1     /dev/did/rdsk/d4s0
EOF

    4. Configure the metadevices.


      Vigor5# metainit -s dg_d1 -a

    5. Create a Mount Point for the SVM Highly Available Local File System.


      Vigor5# mkdir /zones

    6. Add the SVM highly available local file system to /etc/vfstab.


      Vigor5# cat >> /etc/vfstab <<-EOF
/dev/md/dg_d1/dsk/d100 /dev/md/dg_d1/rdsk/d100 /zones ufs 3 no logging
EOF

    7. Create the File System.


      Vigor5# newfs /dev/md/dg_d1/rdsk/d100

    8. Mount the File System.


      Vigor5# mount /zones