To Back Up Data Using Legato Networker

Steps

1. Create a symbolic link from /usr/lib/nsr/imsasm to msg_srv_base/lib/msg/imsasm

2. From Sun or Legato, obtain a copy of the nsrfile binary and copy it to the following directory:

   /usr/bin/nsr

   Note that this is required only if you are using an older version of Networker (5.x). With Networker 6.0 and above, nsrfile is automatically installed under /usr/bin/nsr.

3. If you want to back up users by groups, perform the following steps:

   1. Create a backup group file as described in To Create Backup Groups

   2. To verify your configuration, run mkbackupdir.sh.

      Look at the directory structure created by mkbackupdir.sh.The structure should look similar to that shown in Table 18–4.

      Note that if you do not specify a backup-groups.conf file, the backup process will use the default backup group ALL for all users.

4. In the directory /nsr/res/, create a res file for your save group to invoke the mkbackupdir.sh script before the backup. See Table 18–4 for an example.

   ---

   Note –

   Earlier versions of Legato Networker have a limitation of 64 characters for the save set name. If the name of this directory plus the logical name of the mailbox (for example, /primary/groupA/fred) is greater than 64 characters, then you must run mkbackupdir.sh -p. Therefore, you should use a short path name for the -p option of mkbackupdir.sh. For example the following command will create the backup image under the directory /backup:

   mkbackupdir.sh -p /backup

   Important: The backup directory must be writable by the message store owner (example: inetuser).

   ---

   Table 18–6 shows a sample backup groups directory structure.

   /backup/primary/groupA/amy /bob /carly /groupB/mary /nancy /zelda /groupC/123go /1bill /354hut

   The example below shows a sample res file named IMS.res in the /nsr/res directory:

   type: savepnpc; precmd: "echo mkbackupdir started", "/usr/siroe/server5/msg-siroe/bin/mkbackupdir.sh -p /backup"; pstcmd: "echo imsbackup Completed"; timeout: "12:00 pm";

   You are now ready to run the Legato Networker interface as follows:

5. Create the Messaging Server save group if necessary.

   1. Run nwadmin.

   2. Select Customize | Group | Create.

6. Create a backup client using savepnpc as the backup command:

   1. Set the save set to the directory created by mkbackupdir.

      For a single session backup, use /backup

      For parallel backups, use /backup/server/group

      Be sure you’ve already created group as defined in To Create Backup Groups

      You must also set the parallelism to the number of backup sessions.

      See To Back Up Data Using Legato Networker.

7. Select Group Control | Start to test your backup configuration.

   Example. Creating A Backup Client in Networker:

   To create a backup client in Networker. From nwadmin, select Client | Client Setup | Create

   Name: siroe Group: IMS Savesets:/backup/primary/groupA /backup/secondary/groupB /backup/tertiary/groupC . . Backup Command:savepnpc Parallelism: 4