"trp0: error 12 INSUFFICIENT MEMORY"
There is insufficient memory available to allocate transfer buffers. Try reducing the maximum frame size and re-booting your system.
"trp0: error 35/21 ADAPTER_INIT_FAILED"
and
"trp0: error 35/33 BUD_FAILED"
The adapter hardware failed to initialize. Please contact Sun Technical Support.
"trp0: error 35/22 ADAPTER_TIMEOUT"
The adapter took too long to initialize. Ensure that all token-ring lobe cables are properly attached and re-boot your system. If the problem persists please contact Sun Technical Support.
"trp0: error 35/25 OPEN_FAILED"
The adapter failed to open onto the Token Ring. The most likely cause is that the lobe cable is not correctly attached to the adapter or to the hub. Other possible causes are that the driver is set to the wrong ring speed or that the driver is using an alternative address that is already in use on the Token Ring.
"WARNING: trp0: lobe cable fault - please check cabling"
The lobe cable has been removed from the adapter.
"WARNING: trp0: ring is beaconing"
The Token Ring has entered beacon state. This is part of an error recovery procedure. If you see this message repeatedly over a short period of time then contact your network administrator. Note: this warning is often seen when the lobe cable is removed. In this case the warning may be ignored.
"WARNING: trp0: adapter is single station"
Your system is now the only system connected to the Token Ring.
"WARNING: trp0: ring has entered recovery mode"
The Token Ring has entered recovery. This is part of an error recovery procedure. If you see this message repeatedly over a short period of time then contact your network administrator. Note: this warning is often seen when the lobe cable is removed. In this case the warning may be ignored.
If any other errors are displayed by the trp device then carefully note any error numbers and text and contact Sun Technical Support.
