7.3.1 How to Replace SBus Cards

1. Switch ownership of the logical hosts from the Sun Cluster node that needs an SBus card replaced.

   For instance, if the board is being replaced on the physical host phys-hahost2, enter the following:

   phys-hahost1# haswitch phys-hahost1 hahost1 hahost2

2. Stop Sun Cluster on the affected node.

   Run the scadmin(1M) command with the stopnode option on the host that has the failed SBus card.

   phys-hahost2# scadmin stopnode

3. Halt and power off the affected node.

4. Perform the hardware replacement procedure.

   Refer to the instructions in the appropriate hardware service manual to replace the SBus card.

5. Power on the node and start the cluster software on the node.

   # scadmin startnode

   The node automatically will rejoin the Sun Cluster configuration.

6. Switch the logical hosts back to the default masters, if necessary.

   If manual mode is not set, an automatic switchback will occur.

   phys-hahost1# haswitch phys-hahost2 hahost2