This section describes the steps to install, configure, register, and start Sun Cluster HA for Tivoli. You must install and set up Sun Cluster and the Tivoli product before configuring Sun Cluster HA for Tivoli.
You will configure Sun Cluster HA for Tivoli by using the hadsconfig(1M) command. See the hadsconfig(1M) man page for details.
On each Sun Cluster server, install the Tivoli package, SUNWsctiv, in the default location, if it is not installed already.
If the Tivoli package is not installed already, use the scinstall(1M) command to install it on each Sun Cluster server that is a potential master of the logical host on which Tivoli is installed.
Run the hadsconfig(1M) command on one node to configure Sun Cluster HA for Tivoli for both the server and managed node.
Use the hadsconfig(1M) command to create, edit, and delete instances of the Sun Cluster HA for Tivoli data service for both the server and managed node. Refer to "Configuration Parameters for Sun Cluster HA for Tivoli" for information on input to supply to hadsconfig(1M). Run the command on one node only.
phys-hahost1# hadsconfig |
Only the Tivoli server and Tivoli managed node should be configured as instances under the control of Sun Cluster. The Tivoli managed nodes used for probing need not be controlled by Sun Cluster.
Register the Sun Cluster HA for Tivoli data service by running the hareg(1M) command.
Run the command on only one node.
phys-hahost1# hareg -s -r tivoli |
Use the hareg(1M) command to enable Sun Cluster HA for Tivoli and perform a cluster reconfiguration.
Run the command on only one node.
phys-hahost1# hareg -y tivoli |
The configuration is complete.