Name of the instance 

Logical host name used as an identifier for the instance. The log messages generated by Sun Cluster HA for Lotus refer to this identifier. The hadsconfig(1M) command prefixes the package name to the logical host name you supply. For example, if you specify "hahost1," hadsconfig(1M)produces "SUNWsclts_hahost1."

Logical host 

Name of the logical host that provides service for this instance of Sun Cluster HA for Lotus. 

Base directory of product installation 

Rooted path name specifying the location on the multihost disk of the HA Lotus installation. This is the "instance path," for example, /hahost1/lotus-home/lotus_1.

Configuration directory 

The directory of the database, for example, /hahost1/d1/Lotus/database.db.

Remote probe 

Specifies whether the Lotus fault probe will probe the remote host. Default value is n.

Local probe 

Specifies whether the Lotus fault probe will probe the local host. Default value is y.

Probe interval 

The time, in seconds, between fault probes. The default interval is 60 seconds. 

Probe timeout 

The time, in seconds, after which a fault probe will time out. The default timeout value is 60 seconds. 

Server port number

Unique port for this instance of Sun Cluster HA for Lotus. The default port number is 1352. 

Takeover flag 

Specifies whether a failure of this instance will cause a takeover or failover of the logical host associated with the data service instance. Possible values are y (yes) or n (no). Default value is y. Values are described in "Configuration Parameters for Sun Cluster HA for Lotus".

Lotus server type 

This parameter is meaningful only for configurations using Lotus Domino 4.6.3. The default value is single. When configuring a Lotus Domino server or a primary partitioned server, always use the default value. When configuring additional partitioned servers, use any value besides single.

Lotus password file 

This parameter is meaningful only for configurations using Lotus Domino 4.6.3. The default value is default_file. When configuring a Lotus Domino server or a primary partitioned server, use the default value, because no password is required for start up. When configuring an additional partitioned server, enter the name of the file in which the password for the additional partitioned server startup resides. If the Lotus Domino server is installed on a shared disk, make sure the password file is available on all cluster nodes, or install the password file on the shared disk.