test

SunVTS 5.0 Test Reference Manual

dpmtest Command-Line Syntax

/opt/SUNWvts/bin/dpmtest standard_arguments -0 dev=[device name], path=[Default|Both],lb=[Enable|Disable],fwtest=[Enable|Disable]

Table 13-3 dpmtest Command-Line Syntax

Argument 

Description 
-0 dev=[device name]

[device name] is the path name of the device being tested.
path=[Default|Both]

Default: Test runs using the interface through which the test was registered. If the device tested is an SES device, then the dpmtest tests the device over fiber channel interface. If the device is registered as an SSC100 device, then it tests over the 12C interface.

Both: If selected, the test runs the same tests to this device over both the Fiber channel interface and the 12C interface.  

Note: This option will be grayed out if both paths are not available. 

lb=[Enable|Disable]

When enabled, the subtest will cause the SES device to loop a packet around the fiber bus with varying data patterns. The device reads the packet after the packet is received, and verifies that the data payload is correct. 

Note: This test will be grayed out in the case where the SSC100 does not have access to the fiber bus. 

fwtest=[Enable|Disable]

When enabled, this subtest runs the system friendly embedded firmware tests on the SES/SSC100 device.