test

SunVTS 5.0 Test Reference Manual

dpttest Command-Line Syntax

/opt/SUNWvts/bin/dpttest [standard_arguments] -o dev=dev_serial_number, dma=Enable|Disable,bist=Enable|Disable, memchk=Disabled|16M|32M|48M|64M|128M|192M|256M

Table 14-3 dpttest Command-Line Syntax

Argument 

Description 

dev=dev_serial_number

Specifies the serial number of the target card to test. The serial number can be found on a label on the back side of the main card. Do not reference the serial numbers of the battery unit or the SCSI daughter card.  

There is no default value. This option must be specified. 

dma=Enable|Disable

Enables or disables the DMA subtest.  

Default--Enabled for functional test mode, disabled for connection test mode. 

bist=Enable|Disable

Enables or disables the BIST subtest. Default--Enabled for all test modes. 

memchk=Disabled|16M |32M|48M|64M|128M |192M|256M

Specifies the amount of memory to check with the Memory Check subtest. If disabled, no memory verification is done. If the value is set to one of the valid values, the test verifies the configuration of that amount of memory in the adapter. Default--Enabled for functional test mode, disabled for connection test mode. Note: Sun currently supports 64 megabytes of cache on the SRC/P Hardware RAID card. To check the memory amount, set "Check Memory" to 64 M. 

Note -

64-bit tests are located in the sparcv9 subdirectory: /opt/SUNWvts/bin/sparcv9/testname. If a test is not present in this directory, then it may only be available as a 32-bit test. For more information refer to "32-Bit and 64-Bit Tests".