To Install Solaris 10 Update 2 on the Open Telecommunications Platform Servers

Before You Begin

• Review the following Solaris 10 Update 2 installation guides: Solaris 10 Installation Guide: Basic Installations, and Solaris 10 Installation Guide: Custom JumpStart and Advanced Installations

• If the hard drive contains partitions, delete the partitions before installing the Solaris OS.

1. When prompted for the Type of Install, choose Custom Install.

2. When prompted to provide the Ethernet port selections, assign the IP addresses, netmask, and gateway values according to your network architecture.

3. When prompted for the Software Group, choose Entire Distribution Plus OEM.

   ---

   Caution –

   If you do not choose Entire Distribution plus OEM, Open Telecommunications Platform installation and configuration will fail.

   ---

4. When prompted for disk selection, choose all available disks.

5. When prompted to lay out file systems, partition the system disk according to the requirements listed in Table 3–1.

Next Steps

When Solaris 10 Update 2 installation has completed and the server has rebooted, perform each of the following procedures in sequence to configure the operating environment.