About This Documentation (PDF and HTML)
Server Module and Components Overview
About the Sun Blade 6000 Modular System Chassis
Powering On and Off the Server Module
Preparation Procedures for Service and Operation
Preparing the Server for Service
Preparing the Server for Operation
Component Removal and Installation Procedures
Removing and Installing Flash Modules
Removing and Installing the Energy Storage Modules
Removing and Installing the Service Processor Board
Removing and Installing USB Flash Drives
Removing and Installing a CPU and Heatsink Assembly
How to Replace the Motherboard Assembly
Diagnostic and Maintenance Information and Procedures
Diagnosing Server Module Hardware Faults
BIOS Power-On Self-Test (POST) Codes
Server Module Maintenance Procedures and Information
The Sun Blade X6275 M2 Server Module has two nodes. Each node has its own indicator panel on the front of the server module. The indicator panel shows the status of the node and can be used to power on and off the nodes. The state of the Power/OK LED indicates the power mode . The power button is used to power on the server module from standby mode to full power mode and to power off the server from full power mode to standby power mode.
Note - To remove power from the server module, you must disconnect the server module from the chassis mid-plane.
|
See also: